Kevin Jonker
Well-Known Member
When clutch is pushed in loud screeching! The clutch setup, pilot bushing and Ram billet flywheel don't have 1000 miles and 7 1/4 mile passes on them. It's a centerforce dual friction with their T.O bearing. Does it look like the fingers on the clutch are not being evenly pressed down? I might have had the clutch adjustment to far to where the T.O bearing was over extending, but only for a couple of runs down the 1/4 at the most. Also the input shaft on the trans will move from side to side and all around in the bearing retainer but spins easily. Also on a side note, the trans has had an issue going into rev. You had to turn the motor off to get it into rev (major grinding), (I adjusted the shifter lever alignment using the hole). Out of the blue one day rev works fine!? Don't understand that at all! Thanks for all your input. Kevin