Best guess on 434" sbm

-
Would you mind sharing the crank and rod manufacturer? Did you stay with MOPAR specs or go with the smaller rod pins? Thanks, Dan
 
K1 4.125" crank, callies rods, diamond gas ported pistons. I went with the smaller rod journal, 2.0 I believe.
 
Thanks! Appreciate the answer. I want to do the same with my 72 360 block. Had the cylinders sonic check and have tons of material left after a .030 clean up bore. Dan
 
We have used several different programs to see where I'm at with my build. Most programs say i need 633 hp to hit 10.70 in the 1/4.

With the parts that I have going in this 434", I think I will be around 650 hp
 
79410aspenrt said:
We have used several different programs to see where I'm at with my build. Most programs say i need 633 hp to hit 10.70 in the 1/4.
With the parts that I have going in this 434", I think I will be around 650 hp
Click to expand...

It will look good with a 10.60 on the window and the wheels in the air.:burnout:
 
dusmon said:
It will look good with a 10.60 on the window and the wheels in the air.:burnout:
Click to expand...

:supz: that would be awesome if I could pull 10.60's.

With 590-600 ft lbs I should have wheels in the air:burnout:
 
You must log in or register to reply here.
-

Back
Top