SirDan
Well-Known Member
car is a 73 dart swinger that was orginally power disc and auto trans but converted to manual disk and 4 speed using parts from a 76 duster.
The brakes are all bled out and feel good just the pedal is high. Its about an inch higher than the clutch pedal. The rod measures 6 1/4 inches from the middle of the bolt hole to the tip and has no adjustment just a solid rod.
Not sure why it is so high up there. I'm thinking to fix it to either cut the rod down and weld it or make a spacer for the master cylinder. Any suggestions or help?
The brakes are all bled out and feel good just the pedal is high. Its about an inch higher than the clutch pedal. The rod measures 6 1/4 inches from the middle of the bolt hole to the tip and has no adjustment just a solid rod.
Not sure why it is so high up there. I'm thinking to fix it to either cut the rod down and weld it or make a spacer for the master cylinder. Any suggestions or help?