Can anyone id these headers
- Thread starter 67Mopar
- Start date
-
Picture to small and I can not enlarge it. Though they look like a standard header.
GTXperience
Orig Stealth Mod
Ditto.
67, where did you get these images? Do you have any of the original/larger files?
mikedevore
Well-Known Member
They Will Fit A , B , E , & F-body Small Blocks. Several Mfg's Sell This Universal Style Of Header. They Should Be A 1 5/8" Primary Tubes With A 3" Collector.
I played with the image, loaded it onto comcast host, and it just comes up thumbnail, we were having a very difficult time trying to get these on a 72 scamp 318 car, undid mounts lifted motor as high as possible etc, did not try from the bottom up, so here is the p[lan undo center link, and try and push up from bottom sound about right? Any other tips? I know its a shoehorn fit, but this was rediculasly tight
mikedevore
Well-Known Member
separate the drag link, install the left side up from the bottom, with the engine raised. it will be real tight with a power steering box. when you get them on & start driving it, watch out for the drivers side tubes hanging down. its almost impossible to keep from smashing them. good luck!
Walt_Felix
Well-Known Member
It's hard to tell by the tiny thumbnail but they look like the painted version of the Hooker Competition Headers.
There are several companies that sell headers with the same design but they do resemble the Hookers I have on my Barracuda.
There are several companies that sell headers with the same design but they do resemble the Hookers I have on my Barracuda.
I think your steering linkage goes though one header
I had a 70 barracuda 318 that I put headers on and I remember that I had to run a tie rod though one of them
I took them off after about 5 months and put some good 340 manifolds on.
I had a 70 barracuda 318 that I put headers on and I remember that I had to run a tie rod though one of them
I took them off after about 5 months and put some good 340 manifolds on.
Walt_Felix
Well-Known Member
-
