[Found!] Carburetor kickdown Rod

[66fyssh]

I'm looking only for a 4bbl slotted Kickdown rod from the carburetor to the bracket at the back of the head.

Thanks in advance!

 

[rbkt65]

what length rod does it have to be. i have 14 or 15 of them getting ready to go to cedar falls swap meet. does it need to be adjustable or no? approx length please? i can look in morning.

 

[66fyssh]

Thanks!

I'm out with my dogs, I'll measure and let you know in about 15 minutes.

 

[66fyssh]

Thanks again.

My current setup uses a solid rod, but when the throttle pressure is set correctly, it won't allow the throttle to go all the way open.

From the rod hole in the head bracket to the carburetor throttle adapter pin, it's 11". My current rod is adjustable and the main rod is 9", then the adjuster is 2.5". Running an Edelbrock 750 on an air gap on a 5.9 Magnum using the Kickdown bracket on the head from my 273.

Here's what I have now.

I appreciate you looking tomorrow to see what you have!

 

[physixx]

I have these rods if they will work.

Ken
Edison, NJ

 

[66fyssh]

I have these rods if they will work.

Ken
Edison, NJ

View attachment 1715579781

Thanks Ken! Appreciate you responding.

Rbtk65 had one that will work! I'll mark it found.

Terry