Chrysler power steering pump seal kit gasket?

[68 CUDA FORMULA S]

Can anyone tell me where this upper center gasket goes from the Chrysler power steering pump seal kit? I did not find one when it came apart. Kind of a shitty picture but it's flat and gasket paper material.
Thanks
Bob

 

[SGBARRACUDA]

Is it a Federal or TRW pump?

 

[Murray]

That gasket aligns with the two bolt holes at the rear. I have never used it.

 

[SGBARRACUDA]

You must have a TRW pump. That’s the only one I’ve seen with that gasket.

 

[4spdragtop]

I had same one leftover I believe.Mine was trw. Does it align with tank holes?
TRW ps pump question

Can anyone tell me where this upper center gasket goes from the Chrysler power steering pump seal kit? I did not find one when it came apart. Kind of a shitty picture but it's flat and gasket paper material.
Thanks
Bob

View attachment 1715851870

 

[68 CUDA FORMULA S]

Yes it is a TRW pump, and just like yours Steve mine only has the one bolt hole in the tank. I did look at your "TRW ps pump question" and it was suggested not to use the gasket by other members so I will not. Also I have read that some other members say to use a thin film of gasket sealer on the big O ring just in case of imperfections in the reservoir tank, has anyone else done this?
Thanks Bob

 

[SGBARRACUDA]

I have not rebuilt a TRW pump. But I have rebuilt Federals and Saginaws. I don't use any sealer on the new Tank O ring and have had no problems.

 

[68 CUDA FORMULA S]

Thank you all for your input.
Bob