Dart GTS longitudinal stripe dimensions ?

[MileHighDart]

I already posted this in the body/interior/section but I think a lot of people dont look at that section very often so i'll try here.

Any one know what the dimensions of this stripe are. Thinking of removing my aluminum trim, filling the holes and doing a stripe like this. But I was thinking i'd rather get the stripes from the local paint store and do it myself cause I like the stripe to go all the way to the front and rear of the car. The aftermarket GTS stripes stop short of the ends of the car.

Anyone have this stripe that they could measure for me ?
I need to know the width of the wide stripe, the width of the small stripes, and how much gap between the stripes.

Thanks
My car would be white with red stripe just like the one in this pic.

 

[1967DartGT]

Can you get an idea base on the size of the turn signal marker?

 

[Longgone]

The small stripes measure 1/4" with a 1/4" spacing. The large stripe is 1". HTH.

 

[MileHighDart]

Thanks LongGone, thats exactly what I was looking for.

 

[Longgone]

Thanks LongGone, thats exactly what I was looking for.

You`re welcome, those numbers came from the original stripe. I measured a repro and the measurements were off as much as a 1/16th in some areas.

 

[spsystems]

does anyone know if the stripe goes under the GTS emblems on the front fenders or if it stops on either side of the emblem. I need to know what was factory i have seen a few pictures of the either way.
Thanks

 

[2darts]

I'm pretty sure that they do not go under the GTS nameplate

 

[Longgone]

No, they do not go under the GTS letters.