moparmarkk
Well-Known Member
Hi, just installed a wing on dart sport, deck lid will not stay up, how do you adjust the bars that hold it up? Thanks ,Mark
I did not realize that you could do that. I learned something new. Thanks.Oh, are you asking how to adjust the bars? I use a large screw driver to pry the bar out of one adjustment hole and on to the next one. This will likely chip the paint both on the bar and around the adjustment holes. If you tape both areas, it may help in keeping that to a minimum. I'm sure Chrysler had some sort of specialty tool for that job, but, I haven't seen one. I tried using an overhead cam spring compressor I had laying around, but, it wouldn't quite get the job done. It just wasn't strong enough to both lever the torsion bars and also pry them away from one hole and on to the next.