Disk Brake Swap - Brake Pushrod Question

[cudakid67]

Swapping 73-76 power disk setup on my 67 barracuda. I have the original manual brake pushrod. I'm guessing it is too short, can someone point me in the right direction of the correct pushrod I need for my power brake master cylinder.

 

[halifaxhops]

Get a adjustable one think Dr. diff has them in assorted sized just measure it close and get that range.

 

[gregpurcell]

The POWER disc linkage doesn't use a pushrod. It uses a swivel linkage setup. The one on the 73-76 will work just fine if you use the corresponding booster.

 

[cudakid67]

The POWER disc linkage doesn't use a pushrod. It uses a swivel linkage setup. The one on the 73-76 will work just fine if you use the corresponding booster.

That's what I was thinking. Unfortunately I don't have that part, I just have my old pushrod. Is the swivel linkage setup available from any suppliers?

 

[gregpurcell]

I've had several of them but I'm out.. they come on every power brake setup on 73-76 A bodies. I'm certain an FABO member can fix you up with one

 

[gregpurcell]

here's pics of the last set I had:
[SOLD] - 67-76 A body Power Brake Swivel $25

 

[cudakid67]

here's pics of the last set I had:
[SOLD] - 67-76 A body Power Brake Swivel $25

Thanks for sharing Greg, that shows me exactly what I need. I'm only in need of the L shaped bracket that goes through the firewall. I have the bracket and the middle swivel piece. Thanks again, very helfpul!