[FOR SALE] Dodge Plymouth Truck 8 3/4 rear housing with axels and backing plates
- Thread starter 1967Barracuda
- Start date
-
- Status
1967Barracuda
Well-Known Member
Not exactly sure on the year but I can definitely measure this thing for you no problem.
JDMopar
Well-Known Member
Some measurements in the very useful thread linked below. Put it on the pickup truck forum too if you're a member. People with 80's trucks hunt these things to swap in. GLWS!
www.forabodiesonly.com
An accurate 8 3/4" rear axle width list
Ok, so, I've posted parts of this list a few times, normally in response to some of the really inaccurate charts and lists that are out there and posted too frequently. It's not my list, I sourced it from the internet but I can't remember where. Since the time I downloaded it several years ago...
www.forabodiesonly.com
1967Barracuda
Well-Known Member
Based on the flange to flange measurements this Axel is definitely a 1965-1971. Thanks for the post. 58 5/16 inches flange to flange and not 59 inch plus for the 72 and up.
1967Barracuda
Well-Known Member
I'm dead wrong it is for a 1972 and up
1967Barracuda
Well-Known Member
1967Barracuda
Well-Known Member
5 x 4 1/2 wheel bolt pattern
1967Barracuda
Well-Known Member
Post the truck forum website. I'll apply
JDMopar
Well-Known Member
Scroll down to the bottom of this page....it's part of Joey's network of sites that are all connected. Top left column....Pickup Truck Forum.
- Status
-
