[SOLD] Driveshaft 45"

[mycuda]

3.25 tube 45" long stock IMO.
3.5" od on both u joint ends.

Believe 8 3/4" rear to 727 trans.a body.
Might have trans yoke.if so I will include.
Some surface rust. But rolls straight.
$80 + ship.
Located chicago burbs.

PM for more info.

Thanks Dave

 

[gliderider06]

Is your measurement u-joint center to center or overall length of shaft measured at outer edges of the eyes?
This might work for my Duster.

 

[mycuda]

Yes 45" from center ujoint to center ujoint minus yoke.

 

[oldkimmer]

340 with 727 and 8.75 for 108 wb cars

 

[mycuda]

Sale Pending

 

[pishta]

Juat a question on shipping these, how do you do it? Roll it up in paper and ship? Would be a general question for the board for those who have shipped in past

 

[mycuda]

Juat a question on shipping these, how do you do it? Roll it up in paper and ship? Would be a general question for the board for those who have shipped in past

4x4x48 inch or so cardboard box or triangle box. Both ends 2" styro foam against ujoint ends packed tightly with newspaper and HD clear packing tape
wrapped around circumference,mostly entire box and ends. Can use thin wall PVC pipe and glued caps as well packed similarly.

 

[memike]

Thin wall pvc and two caps us the way I send them out.

 

[pishta]

Thin wall pvc and two caps us the way I send them out.

I used to ship specialty fluorescent bulbs like that , thanks.