driveshaft length duster

[eric202006]

does anyone know the length of a driveshaft with 1350 u joints for a duster. it has a 727 and a 8 3/4

 

[Supershafts]

If you have the slip yoke bottom it out in the trans and measure center to center of the joint, bring that to your local driveline shop and tell them the slip yoke was bottomed out.

If no slip yoke, measure seal to center of joint on the end yoke, and also how far the out put shaft is past the seal or before the seal.

 

[pntastar69]

If you have the slip yoke bottom it out in the trans and measure center to center of the joint, bring that to your local driveline shop and tell them the slip yoke was bottomed out.

Make sure you have approx. 1" of travel on the trans slip yoke.

 

[green1]

A 1350 will fit a 8 3/4?

 

[Supershafts]

Make sure you have approx. 1" of travel on the trans slip yoke.

Leave that for the driveline shop to determine.

Bottom the slip yoke out and take the center to center measurement and let the driveline shop know it was bottomed out.

They'll know what needs to be done, some slips need more than 1"