[WANTED] Driveshafts (2)

[NoCar340]

I'm looking for a couple of driveshafts. Neither is an HP application, so I'd rather not pop for new.

The first shaft is 48.96" long center-to-center per the parts catalog, or near enough to 49". The transmission is an A833OD with the smaller output spline if your 'shafts happen to have yokes attached.

The second shaft could be anything from 45.60" to 45.85", depending on which parts book entry one believes. I would need a 727/A833 large-spline output on this one, again assuming an attached yoke.

Yokes I've got, so if you've got the correct length without a yoke it's fine. 7260 joints are more likely and fine by me.

 

[Oldmanmopar]

Your first shaft is a 108 wheel base 904 or 4 spd - 8 3/4 rear

Your second shaft is a 108 wheel base 727 - 8 3/4 rear

These would be for 108's Duster , Demon, Dart sport, Valiant, or 67-69 Barracuda. They would be cars you could get a factory length you could use.

 

[NoCar340]

Your first shaft is a 108 wheel base 904 or 4 spd - 8 3/4 rear

Or 8-1/4" rear, which is what I have.

Your second shaft is a 108 wheel base 727 - 8 3/4 rear

Nope, it's for a 110" wheelbase Challenger with an A833.

 

[Mtrhead]

The duster shafts I use for 727 to 8 3/4 are 45 in or 44.98