[SOLD] Edelbrock 340 heads

-
Status
Not open for further replies.
stroked340

stroked340

Well-Known Member
Joined
Jun 14, 2014
Messages
5,299
Reaction score
3,010
Location
mass.
Rating - 100%
1   0   0
Contact seller
Part#60179 I had these heads fully c and c ported by Hughes engines,at that time they enlarged the intake valves to 2.08 and had them mill the heads and enlarge the push rod holes,then a local engine builder installed new 1.60 ex.valves,springs,retainers and 10 degree locks (springs are good to .700 lift)note:these are not new heads they are ones I bought new and used on my 416,but have not been installed since all this work was done.. price is $1750.00 at that price these are a "STEAL" new out of the box(nothing done to them cost over $1500.00 these have over $1500.00 additional work done on them..p.m. or email me..thanks.

IMG_0650.JPG


IMG_0651.JPG


IMG_0652.JPG


IMG_0653.JPG
 
*PRICE REDUCED*..$1700.00

Got these heads on a few Mopar forums nothing but negative comments since I cleaned up the intake and exhaust sides with a roloc,trust me those old gaskets were on there and I barely touched the surfaces cleaning them up..most IMPORTANT surface(head to block) was milled by Hughes Engines,anything I cleaned will NOT affect the performance of these heads..plans have changed and I have another set for the 360..somebody must need these:D:D
 
Last edited by a moderator:
*PRICE REDUCED*..$1650.00 PLUS SHIPPING would rather sell local or somewhere close to Boston..
 
Status
Not open for further replies.
-

Back
Top