I just bought a 360 that has these valve covers. How do you get them off? There are only 3 bolts (along the bottom) and there's something else holding them on. Why only 3 bolts?
Saw Zaw or torch
Thanks, chasduster. I found them. Two of the "fake" bolts are real ones.
I run a set and they're the first valve covers I've had that you can leave in place to pull the intake
i thought vic says all his stuff is proudly made in the usa
I've done several sets of those valve covers around here ... lots of blasting (and, as mentioned before, quite a bit of deburring on the Taiwanese construction lol) but they look pretty cool when they're done.
http://i207.photobucket.com/albums/bb82/PhoenixSpecialtyCoatings/WORK SAMPLE PHOTOS/IM006344.jpg
http://i207.photobucket.com/albums/bb82/PhoenixSpecialtyCoatings/WORK SAMPLE PHOTOS/IM005494-1.jpg
http://i207.photobucket.com/albums/bb82/PhoenixSpecialtyCoatings/WORK SAMPLE PHOTOS/IM005507.jpg
http://i207.photobucket.com/albums/bb82/PhoenixSpecialtyCoatings/WORK SAMPLE PHOTOS/IM006128.jpg
http://i207.photobucket.com/albums/bb82/PhoenixSpecialtyCoatings/WORK SAMPLE PHOTOS/IM005493.jpg
Hey ramcharger, I was expecting the same thing as you got when I was waiting for mine. They are actually REALLY nice. You must have got a "fluke" set. I'm usually against any kind of "dress up" stuff, but I have to say that the set I have are preatty cool. They are not "junk". I dont know, I'm actually glad that I'm not using the "elite" air filter as well. I think it is overkill. But that is for me. If I could have scored a good set of commando valve covers that is what my first choice is. These are not even my second choice. I'd say I would rather have some old MT's or similar. But these will work. I plan on sending them to cudachick when money will allow. I'm going to have her do the tops in 273/Chrysler red. Then my water neck is the red and my kick down is also the red. I think it should look really cool. We'll see.
so are those sand blasted and clear on them or is that silver powder coat