For sale: a pair of Edelbrock Small Block Mopar Performer RPM cylinder heads (see upgrades below)
Location: Escondido, CA (North County San Diego). No shipping.
Price: $1200
Payment Method: Cash
For sale: a pair of Edelbrock Small Block Mopar Performer RPM cylinder heads, with some upgraded parts, some minimal port work (Hensley Performance), surface cut and minor fixes, valve job (Brian Hafliger IMM)
These heads were sold to me in September 2008 by Moparts member Irun5snd8th (then Irun6snd8th). They had some minor damage in a couple of places. Irun5snd8th said the heads had Manley valves, and dual valve springs with dampers. According to him, Hensley Performance did some minor work in the shroud around the valves and port matched the intake and exhaust ports.
In October 2008 Brian Hafliger at Indio Motor Machine (IMM), did a surface cut and some minor repairs, did a valve job and tested the springs and said they were set at 1.875 installed height, they measure 131 lbs. on the seat and 300 lbs. open pressure at .500 lift.
After receiving the heads they were stored in my closet for a future engine build that never happened.
I would like to sell the pair locally in Southern California for $1200.
I am in Escondido, CA (North County San Diego)
Thanks,
Ran (kick_the_reverb)
Location: Escondido, CA (North County San Diego). No shipping.
Price: $1200
Payment Method: Cash
For sale: a pair of Edelbrock Small Block Mopar Performer RPM cylinder heads, with some upgraded parts, some minimal port work (Hensley Performance), surface cut and minor fixes, valve job (Brian Hafliger IMM)
These heads were sold to me in September 2008 by Moparts member Irun5snd8th (then Irun6snd8th). They had some minor damage in a couple of places. Irun5snd8th said the heads had Manley valves, and dual valve springs with dampers. According to him, Hensley Performance did some minor work in the shroud around the valves and port matched the intake and exhaust ports.
In October 2008 Brian Hafliger at Indio Motor Machine (IMM), did a surface cut and some minor repairs, did a valve job and tested the springs and said they were set at 1.875 installed height, they measure 131 lbs. on the seat and 300 lbs. open pressure at .500 lift.
After receiving the heads they were stored in my closet for a future engine build that never happened.
I would like to sell the pair locally in Southern California for $1200.
I am in Escondido, CA (North County San Diego)
Thanks,
Ran (kick_the_reverb)
