Fitting it all BB??

[schmitt]

Guys is there a better solution to my problem?

Fuel elbow is hitting the coil mount bracket. I could add a carb spacer and clear it I guess? Where do I mount my coil then though?

 

[schmitt]

Pic

 

[ScampMike]

I've seen a lot of cars with the coil mounted inside the car.. mine is on the floor on top of the trans tunnel and about 4" from the firewall

 

[Dodgeguy101]

Not sure it will give you enough room for the coil, but one of the fitting companies make a shorter fitting to go into the carb. I think I saw it in Jegs catalog.

 

[IQ52]

?

http://www.summitracing.com/parts/fra-491952/overview/

 

[schmitt]

Thanks fellas! I'm going to see if I can bring it up more using that fitting you guys posted without having it hit the linkage on the carb then.

Would running a carb spacer hurt or be beneficial?

 

[schmitt]

Can't bring the line up anymore without hitting the linkage of the carb.

Carb spacer looks to be my only option?

 

[Woods74]

Thanks fellas! I'm going to see if I can bring it up more using that fitting you guys posted without having it hit the linkage on the carb then.

Would running a carb spacer hurt or be beneficial?

1/2" spacer helps with mixture in un-equal plenum intakes like the air-gap. Unless you have the center intake milled down, watch this video:

[ame="https://www.youtube.com/watch?v=Bmj48i_v6-8"]Weiand Vs Edelbrach intake manifold dyno comparison - YouTube[/ame]

 

[Dubob]

I used a vertical mount for the coil.

http://www.manciniracing.com/corebrunmo.html


My RPM intake has bosses on drivers side and passenger.

 

[akrateffil]

I mounted my coil on the fire wall.

 

[zac_F71]

Mounted mine on the fender well..

The fuel line - I plan to do a setup like my old fox body had - pictured below