Floor shift linkage hodgepodge

[skep419]

I can’t seem to find the answer I’m looking for. Which parts are needed for a 1969 dart floor shift? Is there a difference between 727/904 linkages?

 

[Oldmanmopar]

Yes there is.

 

[awg329]

I think the bracket on the tailshaft of the transmission is the same 904 or 727. I found this page Mopar Transmission Parts|Restoration Parts|Jim's Auto Parts

 

[skep419]

I think the bracket on the tailshaft of the transmission is the same 904 or 727. I found this page Mopar Transmission Parts|Restoration Parts|Jim's Auto Parts

I have 2 different torque shafts but I can’t find any info saying the one in the car wouldn’t work with a 727.

Console shifter with 904 linkage to a 727

Lower Shifter Bracket : suit 904/727 Torqueflite Selector Bar

 

[Mopar69gts]

I have 2 different torque shafts but I can’t find any info saying the one in the car wouldn’t work with a 727.

Console shifter with 904 linkage to a 727

Lower Shifter Bracket : suit 904/727 Torqueflite Selector Bar

I can tell you that I swapped my 727 out for a 904 in my 69 dart.
All the linkage stayed the same the only thing I had to do was have a new drive shaft made 4" longer.
Now that was with a Lokar kick down set up.
I do think there is some difference in the factory kick down between the two.
(Lever.)
Since then I put in a Quicksilver cable shifter with a reverse pattern manual valve body so no more kick down stuff to deal with.
I like it so much better.
Hope this helps..

 

[4spdragtop]

I believe there is a difference in the parts in you last 2 pics. I remember someone else having an issue a while back on here.
** edit** maybe I'm wrong?? Mopar69gts above didnt have an issue. You are missing the upper rod, I dont see it in your pics?
Also here's a link from another supplier
1966-73 A Body, 66-70 B & C Body, 70 E Body Automatic Floor Shift Torque Shaft Lower Transmission Bracket-Repro

 

[oldkimmer]

I’ve never had a problem switching from 904 to 727 in any A body car. The linkage may have needed a little adjustment. Kim

 

[4spdragtop]

I dont recognize the piece you're holding in your hand with the 2 holes? I've only ever seen it with one.

 

[Scatpack1]

AWESOME, AWESOME AWESOME info. Thanks everyone for the assist.
Merry Christmas

 

[Tony Barracuda]

Putting in a console shifter would you happen to have any of the linkage stuff you didn’t use. This is what I need. I have the trans bracket.
thanks

 

[4spdragtop]

Check Brewers, they may have a kit.

 

[Tony Barracuda]

Thanks