Demonic
Well-Known Member
Anyone have length and pitch specs for flywheel and pressure plate bolts handy? I figure they’re a bit longer than flexplate bolts at the crank. I’m adding a manual to a 318 that’s going in a Jeep.
Flywheel and pressure plate bolt specs?
- Thread starter Demonic
- Start date
-
Flywheel are 7/16-20 x 0.94"
Pressure plate 3/8-16 x 1.00"
Keep in mind, not generic hardware store fasteners.
Flywheel bolts have a thin head, and the pressure plate are shouldered into the wheel to properly locate the plate.
Pressure plate 3/8-16 x 1.00"
Keep in mind, not generic hardware store fasteners.
Flywheel bolts have a thin head, and the pressure plate are shouldered into the wheel to properly locate the plate.
Demonic
Well-Known Member
I’m having trouble finding part #’s.
☆☆☆☆☆
-
