head gasket question...which one??

[Youngthrill]

im running edelbrock aluminum heads in my 318 board .40 over...what head gasket do i need??

a .028 will get me higher compression but i head someone on hear say a .040 will get me ideal quench...im willing to go with the .40 because there more material mybe prevent a failer down the road..

so wjat im asking is can someone send me a link from summit...??im confused because there are so many fel pro gaskets on there im not sure which ones to get thanks fabo:burnout:

 

[1wild&crazyguy]

whats the piston/deck height at tdc?

 

[sireland67]

LA or Mag?
What pistons?
I am put these on my 360 mag with eddy heads.
They have a smaller bore diameter than most head gaskets I have seen, which will up your compression.
They are also recommended by eddy to use on their heads.

http://www.summitracing.com/parts/DCC-4876048/

 

[Youngthrill]

I went with felpro. 038...I'm running a zero deck 4 valve relief speed pro.

 

[TXDart]

I run these on all my small blocks:
Fel-Pro Q1008
Here's summits link :
http://www.summitracing.com/parts/FEL-1008/

 

[Youngthrill]

cool !!those are the ones i bought......

 

[1wild&crazyguy]

good deal.

 

[604]

I used the thin Mr.Gasket ones. So far no problems.