Hood problem

[mrhollywood]

My 70' Dart hood doesn't sit where it should.....the front seems fine other than if you push one corner down the other goes up. But my issue is the back of the hood sticks up higher than the fenders and vent area...is there a way to adjust the hood to seat properly all the way around?

 

[daredevil]

Loosen the front bolts where it mounts to the hinges. With it open have someone push up on the front edge and tighten the bolts.Should bring the rear down.

 

[Jake 73 swinger]

Are one of your springs bad? with my dart one of the springs was bad so it made it sit uneven in the back.

 

[jefflock]

Loosen the hood hinge bolts slightly. Then carefully close the hood and push down on the back corners to the proper alignment. Then carefully open the hood back up and retighten the bolts. (By just loosening the bolts slightly you can move it and it should stay in place while you open it to retighten them.)