[WANTED] Hyd Roller cam
- Thread starter mderoy340
- Start date
-
- Status
What power level are you wanting to upgrade to? Any other changes going to be made to the engine?
All the components need to play nice with each other.
Suggest you list your compression ratio, intake manifold, carburetion, headers or stock exhaust manifolds, trans type (auto or manual), converter stall if auto trans, rear gearing, suspension mods if any and estimated vehicle weight in order to give our online techs enough info to make a recommendation.
Also, what is the intended usage? Street only, street/strip, etc.
All the components need to play nice with each other.
Suggest you list your compression ratio, intake manifold, carburetion, headers or stock exhaust manifolds, trans type (auto or manual), converter stall if auto trans, rear gearing, suspension mods if any and estimated vehicle weight in order to give our online techs enough info to make a recommendation.
Also, what is the intended usage? Street only, street/strip, etc.
Basically a stock magnum truck engine with a dual plane intake and carb. LA timing cover and water pump. Needs a long snout camshaft.
http://www.ebay.com/itm/1993-2000-D...KIT-/271291790594?hash=item3f2a403502&vxp=mtr
Cam should be something like this.
mderoy340
Well-Known Member
OK I'm looking for a long snout roller cam to upgrade a 300HP Magnum crate motor. Current cam @050 205/196. lift 420/420 and is done at 5k rpm.
I spoke with bullet cams about regrind, approx 2 week turn around.
Figured I'd post a wanted ad and see if someone had a good performance roller cam laying around that they were not going to use.
My budget combo street/strip setup.
67 dart 2 dr post 3000 lbs
360 magnum 300hp crate mopar magnum upgraded springs installed.
M1 dual plane, Demon 750DP, 1 5/8 long tube headers with cutouts.
904 low gear set, TF2 shift kit, /6 convertor Dacco, 3.91 8.75 SG 27" tire
A cam around 220 or 230 @50 should do it.
I spoke with bullet cams about regrind, approx 2 week turn around.
Figured I'd post a wanted ad and see if someone had a good performance roller cam laying around that they were not going to use.
My budget combo street/strip setup.
67 dart 2 dr post 3000 lbs
360 magnum 300hp crate mopar magnum upgraded springs installed.
M1 dual plane, Demon 750DP, 1 5/8 long tube headers with cutouts.
904 low gear set, TF2 shift kit, /6 convertor Dacco, 3.91 8.75 SG 27" tire
A cam around 220 or 230 @50 should do it.
Call Oregon Cams, you won't be sorry....
- Status
-
