65 Valiant
Well-Known Member
Hi guys,
i posted the problem times before:
The 360 engine with its TTI headers don't fit with my original 4 speed Z-bar and components.
I have all the stuff from Brewer's but they don't have any experiences with TTI headers and Sam from TTI has no experiences with early A-body!!
thats stupid.
So i bought a complete hydraulic clutch setup from American Powertrain.
this one:
http://www.americanpowertrain.com/cart.htm#ecwid:category=146603&mode=product&product=706967
who has installed a kit like this one?
i have a A833 4 speed 23 spline. What about the throwout bearing? Does it need a fixing or can i put it on the shaft and thats it??
I found some videos on youtube but the setup they show in the videos looks like this one:
http://americanpowertrain.com/i-852...or-system-for-mopar-with-23-spline-a-833.html
you can see the difference between the throwout bearings.
pls help
thx JAN
i posted the problem times before:
The 360 engine with its TTI headers don't fit with my original 4 speed Z-bar and components.
I have all the stuff from Brewer's but they don't have any experiences with TTI headers and Sam from TTI has no experiences with early A-body!!
thats stupid.
So i bought a complete hydraulic clutch setup from American Powertrain.
this one:
http://www.americanpowertrain.com/cart.htm#ecwid:category=146603&mode=product&product=706967
who has installed a kit like this one?
i have a A833 4 speed 23 spline. What about the throwout bearing? Does it need a fixing or can i put it on the shaft and thats it??
I found some videos on youtube but the setup they show in the videos looks like this one:
http://americanpowertrain.com/i-852...or-system-for-mopar-with-23-spline-a-833.html
you can see the difference between the throwout bearings.
pls help
thx JAN