no1newb
Well-Known Member
I have a problem, i think its the wires from the connector to the ignition switch, at least i hope it is, because i cant tear apart the dash with confidence lol. but does anyone know where i can get one of these harness?
whats happening is the car will start and when its in the start position, and i can bring the key back a little bit so the starter will turn off, but once it goes to on it dies, i dont have a ballast anyone thanks to MSD and the bulk heads were cleaned and seemed fine when i looked at them earlyer this year. i was pulling the ignition switch today and it started sparking on my dash, (I know i should have taken the battery out earlier) but i think it was the wires that were touching the medal back part, not the switch it self, and the key wasnt in it so there shouldnt have been power going around it. i checked the switch with a ohm meter and it was making a current through ign 1 and ign 2 when it was suppose to.
whats happening is the car will start and when its in the start position, and i can bring the key back a little bit so the starter will turn off, but once it goes to on it dies, i dont have a ballast anyone thanks to MSD and the bulk heads were cleaned and seemed fine when i looked at them earlyer this year. i was pulling the ignition switch today and it started sparking on my dash, (I know i should have taken the battery out earlier) but i think it was the wires that were touching the medal back part, not the switch it self, and the key wasnt in it so there shouldnt have been power going around it. i checked the switch with a ohm meter and it was making a current through ign 1 and ign 2 when it was suppose to.
