J Heads

[1wild&crazyguy]

Where would you get that tubing?

Any specific sizes or do you just measure each head/hole?

1/2 or .500 does not interference fit, but with ovaling and/or epoxy it works.

ACE hardware has a listing, mondello.com sells them as well in 1/2 & 9/16 etc..

A reamer is also sold by mondello.com

I went through one today when the grinder bit, I'm gonna tube it.

K&S makes the ace hardware tube, comes 1/2 x 36'' length and is .029 wall

 

[moturbopar]

Hughes sells some base rhs heads for a pretty good price. I think these would be a good upgrade. http://www.hughesengines.com/Index/...cw==&level1=Q3lsaW5kZXIgSGVhZHM=&partid=25739

 

[1wild&crazyguy]

...............I know a guy that has just over $2500.00 into a set of ported X heads..........i told him thats just retarded...........he said that may be but there the #s heads for my engine/car.........go figure..........kim..............

DAAAAAAAAMM:tongue9:

Been wanting to use that one.:-D

 

[1wild&crazyguy]

Hughes sells some base rhs heads for a pretty good price. I think these would be a good upgrade. http://www.hughesengines.com/Index/...cw==&level1=Q3lsaW5kZXIgSGVhZHM=&partid=25739

Yep good heads even in this form, flow like bowl blended x/j heads and have improved closed chambers.