alsdemon
Well-Known Member
just got my hole cut and shifter on trans trying to find pic,s of o/e shifter linkage. i found pic,s of hurst but i think mines differant . i will take some pic,s of my stuff.
looking for linkage pic,s
- Thread starter alsdemon
- Start date
-
alsdemon
Well-Known Member
bump for some pic,s
Robbie2734
Lambcharger
I'll try to post some of my hurst setup on my O/D 833 tomorrow afternoon.
Robbie2734
Lambcharger
This is the O/D trans setup with a hurst shifter. The main difference is the 3/4 shift tab is upside down for the O/D trans.
alsdemon
Well-Known Member
heres my rods the reverse ones a no brainer and the 3/4 must have the bent tab and the straight one is 1/2
Robbie2734
Lambcharger
I bought the new rods from PG Classics, they are thicker and fit well except the reverse rod needed tweaking. I had the Inland shifter before and didn't want to reuse the skinny rods but might go back and grab the old reverse rod for a better fit.
-
