[WANTED] Magnum Cylinder Heads

[thomasfouraker]

Looking for Magnum Cylinder heads with Magnum Intake pattern.

Either factory valve sizes or 2.02 is fine.

Preferably EQ318a but can’t be picky right now. An exhaust valve hung up in my oem heads and when I pulled them they were cracked in between half of the valve seats.

Thanks!

Thomas

 

[rumblefish360]

I have a set. Jacksonville what state?

 

[thomasfouraker]

I have a set. Jacksonville what state?

Florida but I ain’t scared to drive, or pay shipping!

 

[=Max Wedge=]

I have a set of mag heads, exhaust manifolds too....

 

[rumblefish360]

Well, I’m in New York and the tolls have just been increased over the previous $15 a bridge, so, stay warm, save your money. Iron is heavy which equals bucks.

The box is approximately 13X8X22 @ 70-ish pounds.
These heads come off a ‘07-5.9 & the springs and valves are stock. Heads shipped with rockers. No pushrods available. Exhaust manifolds available.

Send me a PM (conversation) to discuss the heads further.

 

[66fs]

I have a good pair of castings. Magnefluxed good and milled. Maybe meet half way or I can check shipping.

 

[=Max Wedge=]

Well, I’m in New York and the tolls have just been increased over the previous $15 a bridge, so, stay warm, save your money. Iron is heavy which equals bucks.

The box is approximately 13X8X22 @ 70-ish pounds.
These heads come off a ‘07-5.9 & the springs and valves are stock. Heads shipped with rockers. No pushrods available. Exhaust manifolds available.

Send me a PM (conversation) to discuss the heads further.
View attachment 1715463412 View attachment 1715463413 View attachment 1715463414 View attachment 1715463416

Rumblefish,

What size valves are those???

 

[rumblefish360]

Stock - 1.92/1.62 or something like that. It’s OE valves.

 

[thomasfouraker]

Will be going to get a set Saturday.

Will keep this open until they are in my possession. Thank you to all who has reached out!