younggun2.0
Well-Known Member
I built myself a console for my kilduff lightning rod shifter. Did it all with a drill press and wood router. Here it is after cerakote. I machined all edges and started final assembly.
My custom console is almost done
- Thread starter younggun2.0
- Start date
-
Plymouth 65
I'll be in the shop
Nice work, bet it looks better with the shifter installed! 65'
JohnnyDart?
As always, nice work! 
dusterbing the peace
FABO pyrite member
That thing is bitchin!!!
Matts440
Well-Known Member
That is sick, amazing job.
Looks great, but how do you keep the coffee from spilling with that cup holder
younggun2.0
Well-Known Member
In the flesh
younggun2.0
Well-Known Member
Gotta be doing a wheelieLooks great, but how do you keep the coffee from spilling with that cup holder
Pretty Flashy.
younggun2.0
Well-Known Member
Almost ready for final install
I'm almost 68 years old but I would say that's RAD! Nicely done.
dusterbing the peace
FABO pyrite member
Did you do the carbon fiber yourself to? Or is it a wrap? Looks killer either way!
younggun2.0
Well-Known Member
The center portion is .25mm thick. It’s like construction paper. It’s a veneer. I get it from protech composites in Vancouver Washington. I cut it all to fit
younggun2.0
Well-Known Member
Console is in the car and done
Hallzy
Well-Known Member
Are those the 11" shifters? Or the daddy long legs?
I intend on ordering myself but I have a split bench so I would like to not have to reach too far your look to be a good length.
younggun2.0
Well-Known Member
These are the 11’s
-
