Mystery part 69 Dart, what is it?

[Steven190]

Been going through the boxes of parts, about 90% done, Just the interior left and getting it to run.

I can across this part and don't know what it is and were it goes.

Anyone know?

Thanks

 

[4spdragtop]

Sure looks like a spacer used in mounting antenna

 

[Steven190]

thanks

were does it go?

 

[4spdragtop]

Under the fender. I believe it acts like a spacer to help take up the slack on antenna mast

 

[jazak5]

It looks like a roofing panel clip for 4x8 sheathing//I have a bunch left in a box//if its used for something else like fenders (who needs them?)

 

[1969383S]

Looks like a plywood clip used on the joint between sections on roofs.

 

[RedFish]

Looks like a plywood clip used on the joint between sections on roofs.

BINGO. I knew I had seen that thing somewhere before.

 

[magnumdart]

Yup, used for roof decking when trusses on two foot centers are used.

 

[4spdragtop]

I agree with the sheathing clip lol BUT looks similar to antenna bracket lol

 

[Steven190]

It was in the parts box. Was wondering where it was in the car.
Now I know.
Thanks

 

[RogerRamRod]

It was in the parts box. Was wondering where it was in the car.
Now I know.
Thanks

Under the back seat?

 

[ScampMike]

it's a derima for the doomaflotchie thingymeboop...

 

[magnumdart]

It is really a rare option used to clip a potato chip bag to the sun visor.

 

[jtkaaa07]

That is a roof clip for sure, installed more of them then I'd like to remember back in my younger years lol! The pic below is an under fender antenna base support


Or you could modify a roof clip too I guess LOL!

 

[harrisonm]

Flux Capacitor?

 

[Steven190]

It was in the box with the right door window mechanizes. I am not sure what it is. It is a little less than 3/8" wide, so if it is for plywood, it is for some thin boards.

Thanks for the reply's.

 

[67Dart273]

I believe this is the correct answer.......

 

[1969383S]

It was in the box with the right door window mechanizes. I am not sure what it is. It is a little less than 3/8" wide, so if it is for plywood, it is for some thin boards.

Thanks for the reply's.

3/8 is to small for a roof clip then. Hmmm! Don't recall seeing anything like that in my Barracuda door and the were completley stripped.