[WANTED] Need a third member 8 3/4 - 2.76 or 3.23

[themoparman73]

Looking for a third member for my 66 dodge dart. I'm going to pull out my 742 case with 4.56 with posi. Want to go with 2.76 or 3.23 single leg. If anyone has one for sale lmk.

 

[74DartSwinger360]

Why not throw the sure grip in with the 2:76s or 3.23s from the 4.56s?

 

[RustyRatRod]

I got a 741 with a 2.76 open in it.

 

[winstoninwisc]

do you want a posi 3:55 or how much should I offer I know where there are 2/ 323 single spins add $50 for shipping pm me direct I have been to buisy with my own blown posi rear and bad back issues so I don't have a lot of time to hunt these threads back down do you know if it has a fine spline yolk or the heavy wide type like a 10 spline

 

[gregpurcell]

I have a cleaned/painted 294 on a 741 case that didn't sell because it has one very small chip on a tooth. It's pictured in the old ebay auction here.
http://www.ebay.com/itm/23101671449...X:IT&_trksid=p3984.m1560.l2649#ht_4423wt_1119
I get $55 for the yokes off these units, so that's all the whole thing is worth to me. The ride will still cost $65-75 to CA though.

 

[highflyer]

Iv got a 355 single leg 741 case a 323 single leg 489 case and a 323 posi 741..if interested let me know..j

 

[themoparman73]

I got a 741 with a 2.76 open in it.

Have any pictures you can send me, also how much. Thanks

 

[themoparman73]

Iv got a 355 single leg 741 case a 323 single leg 489 case and a 323 posi 741..if interested let me know..j

What are you asking for the 3.23 489 case. Thanks Eddie.

 

[65 Dartman]

PM to highflyer

 

[tuckinauster]

I've got a 741 casting 2.76 open third member available. If you're interested, shoot me a PM.

 

[davescuda]

I have 3.23 741 and 3.23 489 if still needed

 

[themoparman73]

I have 3.23 741 and 3.23 489 if still needed

you have any pictures also how much are you asking for each. Thanks, Eddie

 

[davescuda]

i will take some pictures tomorrow and post the pictures and price.

 

[themoparman73]

Don't need this no more. Thanks....

 

[superdart426]

use the thread tool at the top of page and mark it sold...did you find one??