[FOR SALE] NV4500 and 5.2/5.9 Bellhousing
- Thread starter gilberttitan08
- Start date
-
- Status
mopardude318
Well-Known Member
Can you please get a rough measurement from where the bell housing mounts to the block and the center of the rear output u-joint?
curious how much longer this unit is than the np435 in my ‘74 powerwagon. I still might have to move my divorced transfer case back.
curious how much longer this unit is than the np435 in my ‘74 powerwagon. I still might have to move my divorced transfer case back.
gilberttitan08
Mexican Hillbilly!!!
James!!! Whats up man! It’s 3” longer.
mopardude318
Well-Known Member
What’s up my man!
Okay excellent. I think the GM version you have here is the shortest combination of the nv4500 available. My intermediate driveline for the divorced transfer case is 12-1/2“ long, I don’t think it’d be possible to shorten it 3” and still have telescopic ability without moving the transfer case back... hmm. I don’t know. What were your original plans? I seen one of your trucks when I go to the valley ever so often.
why are you selling?
mopardude318
Well-Known Member
Oh, and does the shifter stick though the floor tunnel in the same spot with this trans?
gilberttitan08
Mexican Hillbilly!!!
You’ll have to move the transfer case and cross member back and shorten the rear driveline. I’m gonna go with 46rh. The shifter will be stick out 4.5” back from factory location. At least it was on my W200.
mopardude318
Well-Known Member
What year truck? Mines a ‘74, probably the same situation with all year trucks.
gilberttitan08
Mexican Hillbilly!!!
Mines a 71. May be the same I’m sure.
mopardude318
Well-Known Member
Do you have the Hydraulic pedal assembly from a layer year dodge truck?
gilberttitan08
Mexican Hillbilly!!!
No. I’ve seen them around.
- Status
-
