Part # for Swinger Emblem Barrell Nuts

[70GoMango340]

I need to rescure the Swinger emblems on the quarter fenders of my '70 Swinger 340. I have read previous articles that had link to the part #'s but links have expired. Does someone have the correct part number? I know it a barrell nut for a 1/8" post and 3/16" hole but I am assuming there are multiple based on thickness of the panel they are being used on. Any help would be greatly appreciated.

I did find this description but haven't found a 1/8" stud 3/16" hole #218.

 

[j_anderson]

you could use these

I used these on my scoop emblems

 

[Murray]

For correct pieces Try R/T Specialties.

 

[townsend]

6002852S EMBLEM RETAINER PLASTIC SET OF 5, BODY, 6002852S :Mopar Fasteners, Clips & Hardware

www.rtspecialties.net

 

[70GoMango340]

http://[URL]https://www.rtspecialties.net/proddetail.php?prod=6002852S

[/URL]

Does the inside door panel need to removed to use those fasteners? I found the attached fastner on other forum and was thinking it was correct?

 

[townsend]

Let's start over.
Is this emblem on the fender, door or quarter panel?

 

[Daves69]

https://www.classicindustries.com/product/6027352.html

Looks like Mr. G's are discontinued........

Mr. G's Enterprises - Auto Fasteners

Mr. G's Enterprises refurbishes plastic, makes screw and bolt kits, and has an 8,000,000 auto fastener inventory.

mrgusa.com

 

[70GoMango340]

Let's start over.
Is this emblem on the fender, door or quarter panel?

Quarter fender

 

[townsend]

Since your a new member, let's help you out on Chrysler sheet metal terms.
Fender location is front of car and quarter panel is rear of car.
Combining the words like in quarter fender can be confusing. Just trying to help out.
The number shown in post 4 is the fender location
The quarter panel retainer is 9420263.
It was used on many Chrysler nameplates back in the early 70's.

 

[70GoMango340]

Since your a new member, let's help you out on Chrysler sheet metal terms.
Fender location is front of car and quarter panel is rear of car.
Combining the words like in quarter fender can be confusing. Just trying to help out.
The number shown in post 4 is the fender location
The quarter panel retainer is 9420263.
It was used on many Chrysler nameplates back in the early 70's.

Got it. Thank you.

 

[70GoMango340]

Got it. Thank you.

So rear door panel needs to come out to access putting the nuts on.

 

[DartManPlum340]

So rear door panel needs to come out to access putting the nuts on.

No. These push in from the outside, then the emblem gets pushed into them. I've always called them barrel nuts. Mine are 1/8 x 0.5".

refer to this older post: Swinger Emblem Fasteners ?