[FOR SALE] Parting a 64 Cuda slant six car

-
60 with the bezel



DSC03060.JPG


DSC03059.JPG
 
Prob have the lock. Not sure on the cables. Charlie it is on the dash not the shifter if that matters
That is what I am looking for. I have a couple cable shift trans's, and two PB shifters, but no good cables. I am looking for "affordable" just to have on hand, not the High dollar new ones that take forever to get. My old 66 Cuda, I used a 65 trans, with a 64 full manual valve body, and the PB shifter in a homemade console between the bucket seats. It got a lot of comments.
 
seat belt bolts 20
slant engine headlight harness 40
headlight switch and knob 25

DSC03078.JPG


DSC03079.JPG


DSC03080.JPG


DSC03083.JPG


DSC03084.JPG
 
Circuit board 30
Inst panel 25
trans seals 904 10
Bumpers and boot new 60

DSC03103.JPG


DSC03104.JPG


DSC03106.JPG


DSC03107.JPG


DSC03114.JPG


DSC03115.JPG


DSC03116.JPG


DSC03117.JPG
 
1. Is the carpeting for an automatic or 4 speed?
2. Who is the carpet manufacturer?
3. Do you have the front bumper stabilizers? These are the "Z" shaped bars between the bumper and the fender.
4. I'll take the front speaker frame.
 
Have a ton of proper used bolts unfortunately all in a can. If you need some a pic would be great.
 
1. Is the carpeting for an automatic or 4 speed?
2. Who is the carpet manufacturer?
3. Do you have the front bumper stabilizers? These are the "Z" shaped bars between the bumper and the fender.
4. I'll take the front speaker frame.
These? Just a web pic
1731066320435.png

or these? Have to look
1731066464151.png
 
would you be willing to cut the drivers side inner fender out? i need to to repair a hole in my 66 barracuda from fender well headers. I just need the area from the firewall to the shock tower.
 
would you be willing to cut the drivers side inner fender out? i need to to repair a hole in my 66 barracuda from fender well headers. I just need the area from the firewall to the shock tower.
sure I can actually in good shape 75 and the ride and say 20 deposit?
 
would you be willing to cut the drivers side inner fender out? i need to to repair a hole in my 66 barracuda from fender well headers. I just need the area from the firewall to the shock tower.

1. Is the carpeting for an automatic or 4 speed?
2. Who is the carpet manufacturer?
3. Do you have the front bumper stabilizers? These are the "Z" shaped bars between the bumper and the fender.
4. I'll take the front speaker frame.
Not sure if it is both no sheet inside here is all I have.
DSC03141.JPG
 
-
Back
Top