flathead31coupe
Well-Known Member
is there a difference in ballast if you run points or eletronic,
Did you use the completed system, or just replace the points. That is what I have considering. That is what my friend didI have bypassed the ballast resistor completely after installing a pertronix system. I used a fuse to connect the two wires together to complete the circuit.
One more type... OEM coil was not designed to receive 12 volts full time. It gets 12 volts on one wire during start, lesser volts from another wire routed through a ballast resistor in run.I have bypassed the ballast resistor completely after installing a pertronix system. I used a fuse to connect the two wires together to complete the circuit.
Just points.Did you use the completed system, or just replace the points. That is what I have considering. That is what my friend did