R1A 48 degree block NOT LIGHTENED and UGL Cam

[spdge70]

48 Degree R1A block. Has motor mounts and oil filter threads. UGL cam. Both are new, block on factory pallet, never machined. I might have the cam bearings too, I need to look.

$2000.00 OBO

 

[spdge70]

Going to put it on ebay tomorrow. Here are some pictures, I was hoping that someone here would pick it up. $1500.00

 

[smlveightis]

Damn, that's a very good deal! Here's a bump for ya! GLWS!

 

[dusterdan]

where is it located?

 

[pettybludart]

Yes how about a location before your ad is deleted,see rules with for sale ads.

 

[pishta]

Bel Air, Maryland....Its in his profile if its at his house

 

[dwire67]

What part # on Block?
Is it a 9.20 deck with 48 degree lifter angle?
9.20" 59 R3, there was a large production run of them machined with wrong cam tunnel. Easy to ID, just look @ #5 cam bearing bore, if it's the same size as the #1 bore, then it has a 48 degree cam tunnel in it.
Not to rain on your parade , but if this is what is then it takes a special cam and if LSM will make you one they cost about $800 just for the camshaft

 

[spdge70]

Thanks

 

[spdge70]

Bel Air Maryland

 

[spdge70]

Part Number is P4532435 This is a 48 degree 9.200 deck. Cam Races are uniform in size.

Thanks

 

[spdge70]

Cam has been sold. Just block available.

 

[spdge70]

Item is sold. Thanks!!