Current dilemma is crank/converter sleeve.
Had 318 with pushbutton A904 and converter.
Trans rebuild and converter mod to 3000 stall small snout ?
Putting a 340 that was Manual and need sleeve 1.81 x 1.55 inches per measurements on 340 crank register and inside diameter of current sleeve in 318 that's stubborn to remove. 318 does not need to be torn apart.
Any suggestions for finding said sleeve is appreciated as I've spent a goodly amount of time searching and short of finding machine shop to make I'm at a loss.
Had 318 with pushbutton A904 and converter.
Trans rebuild and converter mod to 3000 stall small snout ?
Putting a 340 that was Manual and need sleeve 1.81 x 1.55 inches per measurements on 340 crank register and inside diameter of current sleeve in 318 that's stubborn to remove. 318 does not need to be torn apart.
Any suggestions for finding said sleeve is appreciated as I've spent a goodly amount of time searching and short of finding machine shop to make I'm at a loss.