Removing ballast resitor and ignition plug

[Sportman]

Hello,

I have a 1974 dart sport 360, with msd 6al ignition. I currently have the ballast resitor removed and the wires jumpered to give me the 12 volt run wire for the msd. I would like to remove the ballast connectors and the old ignition plug from my underhood wiring. If I remove the ballast plugs which wires should be connected together. I have the 7.5 v start wire and the 12 volt run wire jumpered together running to the 6al 12v ign wire at this time. It works, but is there a better way? I am just trying to clean up some under hood wiring.

Thanks for any help.

 

[70aarcuda]

connect the blue and brown wires together that are on the ballast resistor...they are the run and start wires...then remove ballast resistor

 

[412 Stroker]

connect the blue and brown wires together that are on the ballast resistor...they are the run and start wires...then remove ballast resistor

x2 that is what i did. I have a mallory 6al

 

[Sportman]

Thanks guys I wasn't sure if I had to do something wth the other 2 wires.

 

[daredevil]

I did it too. But ran the brown and blue under dash and put the msd behind my glove box and ran the dist. leads thru the firewall.Cleaned it up good.