Seal Orientation

-
dodgedart1968

dodgedart1968

Well-Known Member
Joined
Oct 7, 2021
Messages
184
Reaction score
44
Location
Amston, CT
1968 Dodge Dart with 9" Drum Brakes

This is the steering spindle seal. Which side faces inboard?

20220408_142219.jpg
20220408_142228.jpg
 
Yup, that's what I thought, Look inside the seal, there should be a metal spring, that's the grease side.
 
Max1196 said:
Yup, that's what I thought, Look inside the seal, there should be a metal spring, that's the grease side.
Click to expand...
No, as you can see from the images, there is no spring. Just to confirm, I just looked at both seals, an neither one has a spring.
 
Everything I have worked on usually puts the "hollow" part of the seal towards whatever you want to "keep in".
 
To put it simply, the "hollowed out" side (with the rubber "lip") always faces the lubricant being contained. I.E. the bottom pic faces into the hub.
 
CFD244 said:
Everything I have worked on usually puts the "hollow" part of the seal towards whatever you want to "keep in".
Click to expand...
Except for the tranmission throttle shaft seal... baffling, but the way it goes..
superbirdspring2022leaks 112.jpg
 
The photos I see are right and left, not top and bottom, but, whatever......look at the outer metal ring. The rounded edge goes toward the backing plate and the sharp edge toward the bearing.
 
Professor Fate said:
To put it simply, the "hollowed out" side (with the rubber "lip") always faces the lubricant being contained. I.E. the bottom pic faces into the hub.
Click to expand...
cudamark said:
The photos I see are right and left, not top and bottom, but, whatever......look at the outer metal ring. The rounded edge goes toward the backing plate and the sharp edge toward the bearing.
Click to expand...

I have re-checked, and the images on my screen are displayed one above the other, not side-to-side. Thanks to everyone for your helpful responses.
 
You must log in or register to reply here.
-

Back
Top