[WANTED] Small Block Bell housing

[SammyD273]

Hello FABO, I am looking for a small block bellhousing good for the 10.5 inch clutch for my 1965 Valiant. Hoping to find one available in SoCal.


Thanks

 

[jeff alder]

There was one on ebay right in your back yard not too long ago. I don't have the link but I remember seeing it

 

[jeff alder]

1964-1966 Mopar Dodge Plymouth A-Body 273 V-8 Bell Housing | eBay OREGON $65.00

 

[SammyD273]

Thank you for your reply I was just looking at that post on EBAy when I was posting this Thread. Can you confirm this is what I am looking for? Or is this the smaller 9.5" one?

 

[Professor Fate]

3 or 4 speed? Slant 6 or small block?
Just so you know, '66 and earlier A bodies use a 9 1/2" clutch. If you're upgrading to the later 10 1/2" clutch, you'll need a special pivot mount and modified torque shaft to make it work. Available from Brewer's.
1963-66 A-BODY TORQUE SHAFT 10.5" BELLHOUSING CONVERSION - Mopar A833 4-Speed Transmission & Component Specialists

 

[jeff alder]

Thank you for your reply I was just looking at that post on EBAy when I was posting this Thread. Can you confirm this is what I am looking for? Or is this the smaller 9.5" one?

I think The Professor covered it nicely. You might have the right z bar already I can't remember for sure.

 

[jeff alder]

1964-1966 Mopar Dodge Plymouth A-Body 273 V-8 Bell Housing | eBay OREGON $65.00

This is the correct one for your car but it is the smaller one.

 

[SammyD273]

Thank you. Yes I ordered those parts from Brewers good for the larger bell housing. That is what I am looking to do. Upgrade to the larger later bellhousing. I have most all the parts for that already, Except the bellhosuing.

 

[Professor Fate]

You may want to specify what bearing retainer diameter your transmission has, since there are several variations on bellhousings.

 

[jeff alder]

Thank you. Yes I ordered those parts from Brewers good for the larger bell housing. That is what I am looking to do. Upgrade to the larger later bellhousing. I have most all the parts for that already, Except the bellhosuing.

I only have the smaller ones left in my stash. I dont see a 67 anywhere at the moment.

 

[jeff alder]

Thank you. Yes I ordered those parts from Brewers good for the larger bell housing. That is what I am looking to do. Upgrade to the larger later bellhousing. I have most all the parts for that already, Except the bellhosuing.

make sure this is correct...Bell housing 289 2482 = 10.5