[WANTED] Steering column shaft
- Thread starter 65 CUDA
- Start date
-
- Status
I will have to measure what I have. (if it's where I think) You're looking for the steel shaft that connects to the steering wheel on one end & to the steering box coupler on the other end, correct?
65 CUDA
Well-Known Member
65 CUDA
Well-Known Member
Still might work
One end has splines on it, I'm guessing where the steering wheel mounts, the other end looks like it has a pressed in pin in it. I've had it for quite some time, over 20 years.
Could this be what you are looking for? It came out of a 66 Dart. Not sure if it is correct to car and had a cruise control set up.
The shaft would be appox. 38" long., and as I recall, manual steering.
I have a Mopar Perf. Steel Billet steering adapter
that converts a Power Column to an Manual Column.
Correct length and splines. Real American made part
that has been sitting on the shelf 20+ years. Not a
Chinese new knockoff.
Much easier and way faster than changing the column and can
always go back quickly if needed.
$150. Priority Shipped/Insured
that converts a Power Column to an Manual Column.
Correct length and splines. Real American made part
that has been sitting on the shelf 20+ years. Not a
Chinese new knockoff.
Much easier and way faster than changing the column and can
always go back quickly if needed.
$150. Priority Shipped/Insured
65 CUDA
Well-Known Member
Need pix please send to my phone number (no phone numbers in public forums) this is for your own safety and in the rules of this site.
Last edited by a moderator:
65 CUDA
Well-Known Member
Send pix
Do you still need a steering shaft ? I have a couple.
- Status
-
