Where can I buy a quality steering column shaft coupler for my 72 Demon. Have looked all over the internet, everything I come across says out of stock. This is a manual steering box if it makes a difference.
Steering coupler
- Thread starter andysauto1
- Start date
-
Andy Willy
Active Member
3/4" Round x 3/4" -36 Spline Black Steering Universal Joint Single U Joint Shaft,Total Length: 83mm (3-1/4"). If you search that on Amazon, that’s what I went with
Appreciate the answer back
Is the manual box 36 spline? I thought it was smaller.
I'm not exactly sure what I have size wise. I really need to check
Andy Willy
Active Member
Professor Fate
Push the button, Max...
OP, you need to clarify-
Are you looking for a factory type coupler, a coupler rebuild kit, or an aftermarket U-joint?
Coupler rebuild kits are pretty commonly available, but can be tricky to install correctly your first time. There's some good tutorials in the "How To" articles section of this forum.
If you're looking for a U-joint, do you just want a straight up U-joint or a vibration reducer?
Also be aware that if you use an aftermarket U-joint or vibration reducer, you'll need to cut and shorten your steering column an appropriate amount, being careful to keep factory indexing (or your steering wheel will not be on center).
Input splines for the manual box are 3/4x36, column size I believe is a 3/4 DD.
Beware of cheap internet U-joints, they are just that- cheap. This IS your steering, after all. Stick with Borgeson, Ididit or Flaming River.
Are you looking for a factory type coupler, a coupler rebuild kit, or an aftermarket U-joint?
Coupler rebuild kits are pretty commonly available, but can be tricky to install correctly your first time. There's some good tutorials in the "How To" articles section of this forum.
If you're looking for a U-joint, do you just want a straight up U-joint or a vibration reducer?
Also be aware that if you use an aftermarket U-joint or vibration reducer, you'll need to cut and shorten your steering column an appropriate amount, being careful to keep factory indexing (or your steering wheel will not be on center).
Input splines for the manual box are 3/4x36, column size I believe is a 3/4 DD.
Beware of cheap internet U-joints, they are just that- cheap. This IS your steering, after all. Stick with Borgeson, Ididit or Flaming River.
Mega Parts USA - Reproduction, NOS and Used Mopar Muscle Car Parts
They have the good repair kits. That's all you usually need.
-
