Stop in for a cup of coffee

-
Just getting a quick coffee break and then run the mower a bit more. Don't know if I will get it done. Started a little later than planned cause I had to run for gas.
 
Sounds like Dave and Matt's cruise to my place is on for tomorrow. Expecting them around noon to hang out for a couple hours. Rodney might get his '66 Dart over here too.
Anybody else in the area is welcome to stop in. Just PM me if you need the address!
@halifaxhops @dartnabout ...
 
Sounds like Dave and Matt's cruise to my place is on for tomorrow. Expecting them around noon to hang out for a couple hours. Rodney might get his '66 Dart over here too.
Anybody else in the area is welcome to stop in. Just PM me if you need the address!
@halifaxhops @dartnabout ...
If I leave now I will see you sometime early tomorrow.
 
Sounds like Dave and Matt's cruise to my place is on for tomorrow. Expecting them around noon to hang out for a couple hours. Rodney might get his '66 Dart over here too.
Anybody else in the area is welcome to stop in. Just PM me if you need the address!
@halifaxhops @dartnabout ...
Bit far for me, maybe next time.:lol::thumbsup:
 
Maybe the Duke boys will be in your area. They are actually filming a new movie.
Dukes-of-Hazzard-Gay-Marriage.jpg
 
Last edited:
Cooling system closed up. Alternator brackets almost done. soon i can warm it up and see how cooling system works.
 
Cooling system closed up. Alternator brackets almost done. soon i can warm it up and see how cooling system works.
It has to be better after cleaning all that casting sand out. My 66 273 was loaded to the bottom of the freeze plug holes. The foundry didn't shake much of the sand out of the water jackets. Good thing there's not too much heat at the bottom of the bores.
 
FCBO has it on there the trailer also. Just a bad remake on a old thing will only happen once.
 
-
Back
Top