That's a cool one.
Stop in for a cup of coffee
- Thread starter toolmanmike
- Start date
-
Have to say that's a man cave for sure.
Early Hemi guys go nuts on them. I would grab it but waiting on a response from the guy with all the distributors if he has s early ones. He made me a offer on that lot he listed for 500 shipped. To bad I don't do hall effect ones. Need to figure it out how to do them. Speaking of which I actually finally went through my early stuff Man I have to get on them, have around 50 of them the earliest a 31.
I am a blessed old fart tests for sure
6'7" player playing a 40 year old 4' 8" player
I bought a rotor and a few condensers this morning. All Filko of course. The Condensers are the wire type and not the strap. #Al-243
Some dp take them also. Depends on the application.
Ill keep looking for the strap type. I can always sell off the AL-243's. Any old condenser is better than the new ones.
zkx14
Duster De-ruster
Very wet day here. Looks like it clears out early tomorrow for my day off. And stays that way for Saturday to get my well pump done.
Good Morning
Good Morning
Did you say wet?Very wet day here. Looks like it clears out early tomorrow for my day off. And stays that way for Saturday to get my well pump done.
Good Morning
I have some if needed Mike. Prob not Filko though.
I hope I never have to do mine it is 400' down. Pulled the neighbors with him it was 125 what a pia!Very wet day here. Looks like it clears out early tomorrow for my day off. And stays that way for Saturday to get my well pump done.
Good Morning
dukeboy440
Well-Known Member
ours is 165 feet down and having had to replace it before, a true PITA
Pulling the piping without kinking it is the PIA part. Got his out had sand in the foot valve. Thank god for a tractor.
dukeboy440
Well-Known Member
morning tim. I'm off to go work on the dart. cya later
Just hoarding at this point. Someday when I kick the bucket my kids will throw them away. I should start a instruction booklet. LOL
Timmy!
Mike I got a rare one the other day that I have not seen before a Prestolite "MADE IN USA" cap with copper terminals, have only had aluminum ones before.
Black or tan? That's cool.
zone....
Tan.
That's a dandy.
Might do a thread on the variations. Have around 5 different tans and a crapload of black. That one is right up there with the "made in Canada" one. No idea on the value the reg ones go around 150. Nothing to compare it to.
And if someone has to have it they will pay the price.
-
