Stop in for a cup of coffee
- Thread starter toolmanmike
- Start date
-
@Mattax Rhetorical question, Why do people rewire their car, mess it up, and then ask for help straightening it out?
I dunno!
Someone told 'em was not only a good idea, but would be an upgrade.
Well actually they read it in a magazine
or saw it on the internet
facebook?
Youtube?
OK. Here's a related question.
Why do people buy a wire kit, or an ignition, or really anything from a well known company, and then come here to ask how to install it?
1974 Dart 318 crank, but no start (Solved)
***SOLVED*** Wire from ICM/ECU to Negative side of coil was broken right at crimp, but rubber sleeve held it in place without allowing voltage to pass thru. I know this issue has been beat to death, I've read the posts, watched the videos, and I'm still stumped. 1974 Dart, 318 w/electronic...
www.forabodiesonly.com
@Mattax Rhetorical question, Why do people rewire their car, mess it up, and then ask for help straightening it out?
I pledge to never help another follower of MAD
I pledge to never help another MAD follower
I have to be nuts to help another crazy MAD disaster
I pledge to never help another follower of MAD
I pledge to never help another follower of MAD
I pledge to never help another MAD follower
I have to be nuts to help another crazy MAD disaster
I pledge to never help another follower of MAD
Sounds like you're serious about that. 
Just marking it's spot.
Yep. I figure do it document it with pictures, then post it when it works. Sure there will always be a few Negative Nancy's. I would have done it this way.
3.375 stroke, mine was offset ground for another. 0014 with a 4.310 bore.
Don't think I have seen a Jungle Jim car with a HEMI in it, just big block Chevy's.
That's no air guitar. He is wrestling with the invisible Woman.Toolmanmike usually has his guitar with….
View attachment 1716235480
View attachment 1716235481
View attachment 1716235482
Ok where is the hemi?
Stand corrected.
That cars got points
Thats like buying a box of condoms and all you received is the packaging.
still works.... but you will get complaints
Today I made the mistake of buying a 1/4 # cheese , bacon, weiner..
Just grabbed gone and a large cup of coffee for a quick lunch. Get home, no frigging bacon.
So I micro waved some. Frigging grab and go junk.
Just grabbed gone and a large cup of coffee for a quick lunch. Get home, no frigging bacon.
So I micro waved some. Frigging grab and go junk.
I sure hope so.If not,send it back. I put a "stock replacement" clutch on my Dakota and the damn thing never was loose when cold. Leave the house and it sounded like a B52 going up the street for 15 min or so.
Last edited:
Unconventional
Well-Known Member
Mind made uo for Harvick's Place for Fun. Weather too sketchy. 40-50mph wind warning at the destination, return trip would mean a trip over a 3800' pass with the snow level floating around the 4000' mark. I'll stay sheltered
My world!
I dunno!
Someone told 'em was not only a good idea, but would be an upgrade.
Well actually they read it in a magazine
or saw it on the internet
facebook?
Youtube?
OK. Here's a related question.
Why do people buy a wire kit, or an ignition, or really anything from a well known company, and then come here to ask how to install it?
1974 Dart 318 crank, but no start (Solved)
***SOLVED*** Wire from ICM/ECU to Negative side of coil was broken right at crimp, but rubber sleeve held it in place without allowing voltage to pass thru. I know this issue has been beat to death, I've read the posts, watched the videos, and I'm still stumped. 1974 Dart, 318 w/electronic...
Carburetor for 1978 Chrysler New Yorker with 400 engine
Can the EGR be deleted both on lean burn and non lean burn?
www.forcbodiesonly.com
What is your timing curve?
Like someone else said, every engine is different. My 451 low deck B motor with flat top pistons 015" below deck, Edelbrock Performer RPM heads with .037" Cometic gaskets (any thicker and I'd lose quench) and Lunati Voodoo 60302 mild cam (475 lift, 220/226 @ .050, 112 LSA) is 10.1:1 compression...
www.forbbodiesonly.com
A lot of wind here today.........................I hate the wind we have too many trees.
Are you talking about FABO or the weather?A lot of wind here today.........................I hate the wind we have too many trees.
The weather of course, there is never any nonsense or shenanigans going on here..............................
-
