Stop in for a cup of coffee

-
so who didn't get a sign made "this guy needs a Beer" ??

I think Mr. Benrick was first, then Mr. Hoppy, then mr. keefer. .............who else??
 
You need a Dew sign!

The thermos quads are pretty easy as long as the plastic body is not warped or cracked. Check to see if all the vacuum tubes are tight also. If the adjustment screws are loose it is usually cake to rebuild them.
 
OH YEA, who needs a DEW ....that's right ....This Gal

Rani This Gal 4.jpg
 
All Carbs are fun...Kinda like a puzzle... If you're new at it,,just lay everything out in order as you disassemble, Clean , assemble in order... Easy Peasy...
 
I have two junk ones here for parts if needed, they both have broken adjustment screws which are just about impossible to remove. They are stripped also.
 
Carbs are a breeze, One trick I do is jb weld the aluminum plugs to stop the gas from seeping out, definitely helps.
 
We have to find a place where they can get printed on a steel panel like a sigh, vista print used to do it no idea where now.
 
the spread bore carb is a 9810 so I am not sure of the CFM and if it is too big or not for a 360

on a 360 in an M-body would be sweet
 
halifaxhops said:
We have to find a place where they can get printed on a steel panel like a sigh, vista print used to do it no idea where now.
Click to expand...
I found a couple placesso far. About $40 a sign and no guarantee on how it turns out. I know a girl who works at a sign shop. She's checking for me..
 
You must log in or register to reply here.
-

Back
Top