Just a quick question, I'm installing my rings (sealed power e-251k30) and the top ring has a moly face. There is no dot or bevel on it, it looks the same either way. Can it be installed both ways? Or do I need a new set of rings?
I'm assuming you checked all top rings. Sometimes if you look at the cross section of the ring on the end, you can tell.
I can see that, but these rings are completely different than my old set with the same part number. So I think something is wrong with them, I compared them to two other sets with the same part number.
So I think I figured out what I am going to do. The original box I had was the newer and updated box, I measured and the ring is the same thicknes, but is deeper in the ring land. And there are no dots, so because there are no dots on the first ring just orientent them and put them any way?
No. Throw them in the trash.
No. Throw them in the trash.