Torq. conv. question please help

[mike1965]

I have a 3500 stall and it has some weight's tacked on it , now what I need to no is if this conv. is for a cast crank motor and if it is can I remove the weight's for my motor it has a steel crank.

Thanks for you help

 

[DDodger]

photos?. might be for 360, or balancing weights for neutral balance

 

[oldkimmer]

..........If the weights r on the front between the pads, yes it is for a cast crank, u can usually knock the weights off without a problem........kim....

 

[AJ/FormS]

Take a picture/save the weights. Then you can put em back on if you dont like the TC and decide to sell it.The next guy might need em on there.

 

[mike1965]

Yeah it was for a cast crank so I knocked them off and it's all together now.

Thanks for all the help guy's

Mike

 

[akavaliant1]

Sorry to do this but on this subject I also have t.c with weights but It doesn't belong to the motor does that matter or transmission. Can I use this for my 360-727??please help me

 

[70aarcuda]

Sorry to do this but on this subject I also have t.c with weights but It doesn't belong to the motor does that matter or transmission. Can I use this for my 360-727??please help me

Does not belong to that motor? or does not belong to a 360 motor?

 

[oldkimmer]

...........Ma mopar had different weights for different size engines as well as 2 weights 1 on either side of the drain plug, then ma deleted the drain plug and went with a single fly weight shaped almost like a tiangle......kim.....

 

[AJ/FormS]

Mr Valiant
Could you be any more vague?