TORQUE CONVERTER SEATING QUESTION.

[CFD244]

Hi Folks

I know I've seen it before, someone with a measurement, but I can't seem to find it........

I installed my converter, and pretty sure that I go two clicks...but they were soft. I have measured from the converter ring gear to the edge of the case and get 1.18 inches. Does this sound about right?

Thanks FABO

 

[fshd4it]

As the motor's out of my car right now, I went and measured it for ya. I've got a strong 9/16" from the flexplate pads, and 1 1/4" from the ring gear.

 

[CFD244]

As the motor's out of my car right now, I went and measured it for ya. I've got a strong 9/16" from the flexplate pads, and 1 1/4" from the ring gear.

That's awesome thanks. 1.18 i pretty darn close to 1.25 so I think I am there.