[WANTED] Trunk lid Template needed

[Kevin Ruby]

Asking if anyone here would be willing to provide me with a 1970 dodge dart swinger trunk emblem template?
My trunk lid was replaced at some point, or was a factory mess up and only says Dart.

 

[Dicer]

Kevin I made these measurements when I replaced my trunk lid, this may help you... this is a 70 Dart Swinger.

 

[j061093409]

Dart came on no-340 Darts in 1970. True 340 Dasts had Dart Swinger on the deck lid plus both quarter panels

 

[Kevin Ruby]

Dart came on no-340 Darts in 1970. True 340 Dasts had Dart Swinger on the deck lid plus both quarter panels

This is why I need the template, for my “true 340 car.”
Thanks

 

[Kevin Ruby]

Kevin I made these measurements when I replaced my trunk lid, this may help you... this is a 70 Dart Swinger.

View attachment 1715708291

Thank you for posting this for me. I appreciate the help Dicer.

 

[j061093409]

If you have a trunk lid with DODGE, use the stud from the capital D as the hole fit DART
The other hole is the flower

 

[Kevin Ruby]

If you have a trunk lid with DODGE, use the stud from the capital D as the hole fit DART
The other hole is the flower

View attachment 1715710403

Thank you Joel. That helps a lot. this trunk lid must have been changed out in the very beginning, as it looks to have been on the car just as long as the rest of the panels.
I suppose it could have come from another F4 car.

 

[Kevin Ruby]

 

[str12-340]

1970 trunk emblem - Dodge for non-340 cars - looks just like the one on the hood, but had 2 posts, neither of them in the same place as the hood emblem.

 

[Kevin Ruby]

1970 trunk emblem - Dodge for non-340 cars - looks just like the one on the hood, but had 2 posts, neither of them in the same place as the hood emblem.

Thanks. My trunk lid shown in the picture.
The car is a H code. The deck lid has been changed out at some point earlier in its life.

 

[str12-340]

Did you get all the info/measurements that you needed? I have an H code trunk lid in my parts shed that others have used locally to do the job you are doing

 

[Kevin Ruby]

I have all the measurements for the emblem mount holes, which I’m sure will be just fine. It would have been cool to have an actual paper overlay of an original lid, with holes punched.