U BOLT QUESTION?

-

BARRACUDA340S

Well-Known Member
Joined
May 13, 2004
Messages
1,010
Reaction score
1
Location
MT PLEASANT IOWA
Now that I have the Dana installed I want opinion's on tightening the U bolt's. I have them tight now and will drive the car a few miles when the motor is done. Then I will check them again. Should I torque them to a certain spec or just get them as tight as I can?
 
Bret, the Chrysler Service manual says the rear u bolts should be tightened to 45 ft lbs. Hope this helps...It's suppose to be for the 8 3/4 and 9/3/4 axle rears.
 
Man that seems light don't it. I can almost do 45 pounds with my finger's LOL. I will drive it a bit and let the axle settle in and then TQ'em to 45.

Thanks
 
don't get too carried away cause you can dimple the housing. It may not be a problem with the dana though as I believe the tubes are thicker.
 
That does seem light. I think I would check them a few times just to be sure. At least after each of the first couple of cruises and hard launches.
 
Remember that your contact area is larger with
the u-bolt. Much larger than say a manifold bolt.
You don't need that much torque. To much and you dimple the tube too.
 
-
Back
Top